A Complex Studio With Real-Time Control - Kurzweil K2600 Musician's Manual

Basic Effects Mode
A Tour of Effects Mode
Output D has the output of the Aux bus, which is just the reverb signal, with no dry component,
since the value of Wet/Dry on the AUXFX page is 100%.
Note: If youÕre using the Mix audio outputs, keep in mind they carry the summed signals of audio
outputs A through D. Normally you would assign each of the audio outputs differently. In the example
above, you might set Outputs B through D to Off, or Output A to Off, to avoid overlapping assignments.
Here is the overall structure for this studio:
Figure 9-5

A Complex Studio With Real-time Control

The third studio is a bit more complex, not least because itÕs under real-time control. Getting
real-time control of a studio requires doing some advance work. Most noticeably, you have to
deÞne a program or setup that uses a particular studio, then deÞne a set of FXMods in that
program or setupÑthe FXMods provide the settings that link physical controllers like sliders to
studio effects like wet/dry mix.
Equally importantly, the FX Mode parameter on the Effects-mode page must be set to a value of
Program (if you want only programs to affect studio selection and controls) or Setup (if you
want only setups to affect studio selection and controls)Ñor Auto if you want to affect studio
selection and control whenever you select a program or a setup.
In this example, weÕll work with setup control over a studioÑthe procedure for working with
program control is almost exactly the same.
9-20
Program
output A
output B
-5dB
EQs
Structure of Studio 201
AuxFXBus
FXBus1
MedWarmPlate
Tut Ring Mod
-9.5dB
-2.5dB
FXBus2
Ptc+Flg+Dly145BP
Physical
Mix
output A
+
Output B
Output C
Output D