Advertisement
Quick Links
K2600 ADAT I/O Option User's Guide / OS 4.1 Release Notes
This document explains how to use the K2600 ADAT Digital I/O Option (KADT26) and also provides release notes
for Version 4.1 of the K2600 Operating System. The ADAT Digital I/O Option requires version 4.1 or higher of the
K2600 Operating System.
The K2600 ADAT Digital I/O Option provides 8 channels of digital input and output in the ADAT Optical format.
An optical AES Out connector is also provided (AES In is available on the Sampling Option). This option must be
installed by a qualified Kurzweil service center.
Cable Connections
Use standard optical link cables (TOSlink) to make ADAT and AES connections. Although the format is different,
the same type of cable is used for each type of connection.
When you use ADAT In, the K2600's ADAT Out cable must also be connected to the sending device. The K2600
must be the "master," and the other device(s) must "slave" to it. Output sample rate (and therefore input as well) is
fixed at 48 kHz.
Output Signal Routing
The output signal routing from the ADAT Option is as follows:
A Left -> ADAT channel 1
A Right -> ADAT channel 2
B Left -> ADAT channel 3
B Right -> ADAT channel 4
C Left -> ADAT channel 5
C Right -> ADAT channel 6
D Left -> ADAT channel 7
D Right -> ADAT channel 8
Part No. 910407, Rev. A
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Kurzweil K2600 ADAT IO OPTION - RELEASE NOTES REV A
Summary of Contents for Kurzweil K2600 ADAT IO OPTION - RELEASE NOTES REV A
- Page 1 The K2600 ADAT Digital I/O Option provides 8 channels of digital input and output in the ADAT Optical format. An optical AES Out connector is also provided (AES In is available on the Sampling Option). This option must be installed by a qualified Kurzweil service center. Cable Connections Use standard optical link cables (TOSlink) to make ADAT and AES connections.
- Page 2 K2600 ADAT I/O Option User’s Guide / OS 4.1 Release Notes New Objects included with the ADAT Option New Objects included with the ADAT Option K26ADAT.K26 (included on disk with the ADAT option) provides two programs and a KDFX studio for use with the ADAT option.
- Page 3 K2600 ADAT I/O Option User’s Guide / OS 4.1 Release Notes Software Changes in OS 4.1 Software Changes in OS 4.1 You will notice the following software changes when you load the 4.1 (or higher) K2600 Operating System. Some of the parameters listed here will only display if you install the ADAT Digital I/O Option. EditProg:KEYMAP Page For the PlayBackMode parameter, KDS In 1 through KDS In 8 change to ADAT In 1 through ADAT In 8 .
- Page 4 K2600 ADAT I/O Option User’s Guide / OS 4.1 Release Notes Software Changes in OS 4.1 Minimum , Medium , Maximum —these utilize noise shaping in varying degrees. The noise floor has been essen- tially equalized to make it softer at midrange frequencies, and louder at bass and treble frequencies. The overall power level of the noise is actually higher than at the Flat setting, but due to the ear’s spectral response at low lev- els, the noise floor appears lower at these settings.
Need help?
Do you have a question about the K2600 ADAT IO OPTION - RELEASE NOTES REV A and is the answer not in the manual?
Questions and answers