The Channel/Program (Ch/Prog) Page; Local Program (Localprg); Channel - Kurzweil K2600 Musician's Manual

The Channel/Program (CH/PROG) Page

This is the Þrst page you see when you enter the Setup Editor. Here, you can select programs,
MIDI channels, and MIDI Bank numbers for each of the setupÕs eight zones. You can also solo or
mute each zone, and assign zones to be controlled by the K2600Õs Arpeggiator.
EditSetup:CH/PROG|||||||||||||<>Zone1/1|
||||||||||||||||||||||||||||||||||||||||
LocalPrg:1|Concert|Piano|1||||Out:Prog||
Channel|:1||||||Destination|:Local+MIDI|
MIDIBank:0||||||MIDIBankMode:Ctl|32|||||
MIDIProg:1||||||EntryProgChg:On|||||||||
Status||:Active|ZoneArpeg|||:On|||||||||
<more||CH/PRG|KEYVEL|PANVOL|BEND|||more>
Parameter
Local Program

Channel

MIDI Bank
MIDI Program
Status
Output assignment (Out)
Destination
MIDI Bank Mode
Entry Program Change
Zone Arpeggiation (ZoneArpeg)

Local Program (LocalPrg)

This selects an internal program to play on each zone. As you change the value of Local
Program, notice that MIDI Program and MIDI Bank match the local program and bank numbers
(Program IDs 0Ð99 correspond to MIDI Bank 0, 100Ð199 are MIDI Bank 1, and so on). If you want
to transmit different program and bank numbers over MIDI, highlight either MIDI Program or
MIDI Bank and select a new value. Note that changing the Local Program parameter again will
reset both the MIDI Program and MIDI Bank parameters to match the local program and bank
numbers.
Channel
The Channel parameter deÞnes the MIDI transmit channel for the currently selected zone. You
can set it to any of the 16 MIDI channels. Normally, you will want each zone on a separate MIDI
channel. This is necessary if you want to combine different programs in the setup.
If two zones have the same MIDI channel (and destination), but they have different program
settings, there will be conßicts: no MIDI device, including the K2600, can respond correctly to
two different simultaneous Program Change commands on one channel. The result will be that
only one Program Change will be recognized, and every note played will sound double (if Note
Maps are on). This can create odd and unpredictable timing effects, and will reduce your
polyphony by 50%.
Range of Values
Program list
1-16
Variable, dependent on MIDI Bank Mode
Variable, dependent on MIDI Bank Mode
Status list
Prog, KDFX-A to KDFX-D
Destination list
MIDI Bank Mode list
On/Off
On/Off
Setup Mode and the Setup Editor
The Channel/Program (CH/PROG) Page
Default
1 Concert Piano 1
1
0
1
Active
Prog
Local+midi
Ctl 32
On
On
7-7