Table of Contents
Advertisement
Also as shown in the previous example, you can display the contents of the name table:
Name|Table|Contents|||||||||||||||||||||
Program|231|Funky|GTR|||||||||||||||||||
Program|245|FendJazzBass||||||||||||||||
Program|400|Obie|Warble|Pad|||||||||||||
Program|600|Drawbarz||||||||||||||||||||
Keymap||220|Funk|Guitar|||||||||||||||||
Keymap||229|Jazz|Bass|||||||||||||||||||
|||||||||||||||||||||||||||||||||||||OK|
Notice that the ROM program 50 Studio Kit 1 will not be listed in the name table. Any
dependent objects that are in ROM do not need to be relinked by name. ROM objects are always
directly referenced by their object ID number, since they donÕt get saved in any Þles.
Once the song Þle has been saved, it can be loaded at any time and correctly relinked, as long as
the other Þles containing the necessary programs have already been loaded.
For this type of situation, where you may be working on songs always using a consistent set of
programs, it is beneÞcial to make a macro Þle that can be loaded in one step to direct all of the
various program Þles to be loaded. After that, any time you load a song Þle containing a name
table referencing these programs, the songs should get relinked to the correct programs.
If you happen to have multiple copies of the necessary programs already loaded into different
banks, you can control which bank of programs will be linked to the songs by choosing a certain
bank to load the song Þle into. The relinked programs will be the Þrst set encountered according
to the Relink-by-Name search algorithm deÞned above.
Not Loading the Name Table
There may be a time that you wish to load objects from a Þle containing a name table, but you
donÕt want the K2600 to relink any dependent objects according to the name table. This can be
accomplished by ÒOpeningÓ the Þle from the Load function, and selecting any desired objects
from within the Þle, except the name table. The selected objects will be loaded into the bank you
specify, however the Relink-by-Name mechanism will not function.
Relink-by-Name Processing Time
Normally, the time taken to relink several dependent objects using the name search will be
insigniÞcant, relative to the time it takes to load the data from the Þle. However, if you are
attempting to relink a very large amount of dependents by loading one Þle (say, 200 samples or
so), there may be a noticeable wait while the K2600 searches its object database for the
dependents. If this happens, itÕs best to be patient.
Disk Mode
Saving Files
13-35
Advertisement
Table of Contents
