Eps - Kurzweil K2600 Musician's Manual

Roland
For Roland disks, the hierarchy is a bit different; the objects that can be loaded are called
volumes, performances, patches, and samples. The page that was selected last time a SCSI load
was executed will appear when you initiate the load operation. Following the prompt is the list
of available objects, with the size of the object in kilobytes displayed as well. The top line of the
display will show the number of available objects of the selected type.
Use the soft buttons to highlight the object to be loaded. The layer buttons will take you through
the current object list in increments of 100. Press OK to execute the load. The Bank dialog will
appear. Press OK again, and the object will be loaded. The display will update you on the
progress of the load.

EPS

For EPS disks, the hierarchy consists of Þles and directories. Directories can be nested several
layers deep. When you press the Load soft button, youÕll be prompted to select a Þle or directory
to load from the list of available Þles and directories. The currently highlighted object will be
either a Þle or a directory. If itÕs a Þle, its name and size will be shown following the prompt. If
itÕs a directory, its name appears, followed by (dir) to indicate its type. The Layer buttons will
take you to the Þrst and last Þles of the currently selected directory. Note that if youÕre loading
from ßoppy disks, you wonÕt see any of the displays or soft buttons relating to directories, since
the directory architecture is not supported for ßoppies.
When a Þle is highlighted and you press OK, the Bank dialog appears; press OK again to load
the Þle. When a directory is highlighted and you press OK, you enter that directory, and the list
of Þles and subdirectories in that directory appears, each Þle followed by its size, and each
subdirectory, if any, followed by (dir). The top item in every list you select is always the parent
directory of the Þles below it. Select the top item in a list to go up one directory level.
Pressing the Exit soft button will take you one level back up the hierarchy. Pressing it repeatedly
will take you to the root directoryÑthe directory at the top of the hierarchy. The quickest way to
the root directory is to press the Root soft button. The top line of the display shows you the
name of the currently selected directory (or subdirectory). Pressing the All soft button will load
all Þles in the current directory (but not any subdirectories). The Bank dialog will appear, and
when you press OK, youÕll be prompted to press the Progs button to load program information
in addition to the samples, or the Samps button to load only the samples.
Importing Samples from Other Manufacturers
Disk Mode
13-75