Kurzweil K2600 Musician's Manual page 417

Sampling and Sample Editing
Editing Samples
parameter to 4, then Sample 2 will play on the Þrst, Þfth, and ninth beat of your six-second
Sample 1 segment. The result will look something like the diagram below.
F:MixBeat||||Start:0.000||||End:6.000|||
Tempo:120|Beat:1||Of:4||VolAdj:0dB||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
If you change Beat to 3, Sample 2 will play on beats 3, 7, and 11. If you set Beat to 1 and Of to 6,
Sample 2 will play on beats 1 and 7. If you set Beat to -1, Sample 2 will still play on beats 1 and 7,
but the sound of the sample will change each time, as the start point of the Sample 2 segment
moves forward (later) by one beat each time it is mixed in.
Mix Beat (as well as Replicate and Mix Echo) may seem a bit complicated at Þrst, but if you
experiment with different settingsÑespecially for Beat and OfÑyouÕll quickly begin to get a feel
for what these functions do.
17 Replicate
F:Replicate||Start:0.000||||End:6.000|||
Tempo:120|Beat:1||Of:1||Xfade:0.000|||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
With the exception of two differences, the replicate function is similar to the Mix Beat function.
The primary difference is that the replicate function uses the selected Sample 2 segment to
overwrite (replace) the selected Sample 1 segment, instead of merging the two segments like the
Mix Beat function. This makes it run faster. The other difference is that there is a crossfade
parameter instead of a Volume Adjust parameter. The crossfade parameter lets you smooth the
transition points from Sample 1 to Sample 2.
14-31