Zone Arpeggiation (Zonearpeg); The Key/Velocity (Key/Vel) Page; Low Key (Lokey), High Key (Hikey) - Kurzweil K2600 Musician's Manual

Setup Mode and the Setup Editor

The Key/Velocity (KEY/VEL) Page

Zone Arpeggiation (ZoneArpeg)

Zone Arpeggiation determines whether the Arpeggiator will affect notes played in the current
zone. The Arpeggiator affects only those zones that have this parameter set to a value of On.
For any given zone, the Arpeggiator plays notes only within that zoneÕs Key Range. If the
Arpeggiator, for example, tries to play a C
note will not sound. However, another zone whose Key Range ends at C5 will be able to play the
#
C 4 from the Arpeggiator. Therefore, setting a zoneÕs Key Range can be important in deciding
how it will respond to the Arpeggiator. (A separate set of range parameters, found on the
ARPEG page, determines whether the notes you play get arpeggiated; see Low Key (LoKey) and
High Key (HiKey) on page 7-38.)
The Key/Velocity (KEY/VEL) Page
The Key/Velocity page allows you to set key range, velocity range, transposition, and Note
Maps for each zone.
EditSetup:KEY/VEL|||||||||||||<>Zone1/1|
||||||||||||||||||||||||||||||||||||||||
LoKey:C|-1||Transpose:0ST|||||||||||||||
HiKey:G|9|||Notemap||:Linear||||||||||||
||||||||||||VelScale|:100%||||||||||||||
LoVel:1|||||VelOffset:0|||||||||||||||||
HiVel:127|||VelCurve|:Linear||||||||||||
<more||CH/PRG|KEYVEL|PANVOL|BEND|||more>
Parameter
Low Key
High Key
Transpose
Note Map
Low Velocity
High Velocity
Velocity Scale
Velocity Offset
Velocity Curve

Low Key (LoKey), High Key (HiKey)

The LoKey and HiKey parameters deÞne the note range of the currently selected zone. The
easiest way to change these values is to press the SetRng soft button, which you can Þnd by
pressing either of the more soft buttons. YouÕll be prompted to trigger the notes you want to be
the lowest and highest notes for the zone. When you do, youÕll return to the Setup-editor page,
and the notes you triggered will be reßected in the values for LoKey and HiKey. TheyÕll also be
represented by the lines beneath the program names in the box at the left of the Setup-mode
page. You can set these values with normal data entry methods as well.
You can create ÒnegativeÓ ranges as well. To do this, select the HiKey parameter and set its limit
lower than the LoKey limit. This results in the zone being active at the top and bottom of the
7-12
#
4 in a zone, but that zoneÕs Key Range ends at C4, the
Range of Values
C –1 to G9
C –1 to G9
-128 to +127 Semitones
Note Map list
1-127
1-127
±300%
-128 to +127
Velocity Curve list
Default
C –1
G9
0 semitones
Linear
1
127
100%
0
Linear