Kurzweil K2600 Musician's Manual page 111

using the physical controller of your choice. FXMods provide a convenient way to gain serious
performance ßexibility.
EditProg*KDFX||||||||||||||||All|Layers|
Studio:199|Default|Studio|||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Bus:|Param:|||||Adjust:||Source:||Depth:
Mix||Mix|Lvl||||0.0dB||||OFF||||||0dB|||
FX1||Aux|Lvl||||-12.5dB||MIDI22|||11dB||
FX2||Aux|Lvl||||-6.0dB|||MIDI22|||6dB|||
<more||KDFX|||FXMOD2|FXMOD3|FXMOD4|more>
The top line of the display indicates that youÕre on the KDFX page in the Program Editor, and
that any changes you make will affect all layers of the current program. The second line consists
of the Studio parameter; this identiÞes the studio associated with the current program, and
enables you to change that studio.
The next line identiÞes the Þve parameters that make up each FXMod. Every FXMod uses these
same Þve parameters, although the available values for some parameters depend on the
speciÞcations of the current studio, or on the values of other parameters in the FXModÑor both.
Bus Indicates which bus the FXMod will affect. Every FXMod is associated with a single
KDFX bus. This can be any of the KDFX buses, which include Input A (InA) through
Input D, FXBus1 (FX1) through FXBus4, the Aux bus (Aux), and the Mix bus (Mix).
Param Determines which aspect of the current studio the FXMod will affect. The available
values for this parameter depend on both the value of the Bus parameter, and the
speciÞcations of the current studio.
Adjust Like the Adjust parameter on other editor pages, this enables you to set a Òstarting
pointÓ for your real-time control over the speciÞed aspect of the studio. For example,
you might want to zero a Wet/Dry mix before using a slider to vary it, or change a
cutoff frequency to enhance the harmonics in a particular sound or effect. The
available values for this parameter depend on the value of the Param parameter. The
values you set for the Adjust parameter are not cumulative, as they are in other
editors; they override the programmed settings for the studio used by the program.
Source SpeciÞes which control source youÕll use to modify the studio in real time. You can use
any global control for the source.
Depth The amount that the speciÞed aspect of the studio will be modiÞed by the speciÞed
source. This is in addition to the amount speciÞed by the Adjust parameter. The
available values for Depth depend on the value of the Param parameter.
On the Program-editor page above, the Þrst FXMod affects the level on the Mix bus, overriding
whatever mix level is deÞned for the studio.
The second FXMod cuts the level of the send from FXBus1 to the Aux bus by 12.5 dB. Slider B
(MIDI 22) boosts the Aux level by 11 dB at the top, and returns it to the Adjust value at the
bottom.
The third FXMod does pretty much the same thing as the second, except that it does it to
FXBus2, cuts the signal less, and boosts it less when you move Slider B up.
Program Mode and the Program Editor
The KDFX Page
6-45