Intermec CK61 User Manual page 159

Chapter 5 — Network Support
144
• In Enterprise mode, WPA provides user authentication using 802.1x
and the Extensible Authentication Protocol (EAP). That is, an
authentication server (such as a RADIUS server) must authenticate each
device before the device can communicate with the wireless network.
• In PSK mode, WPA provides user authentication using a shared key
between the authenticator and the CK61. WPA-PSK is a good solution
for small offices or home offices that do not want to use an
authentication server.
To use WPA security, you need an access point with an 802.11b/g radio
that supports WPA.
To configure WPA security with Funk Security
Use this procedure to set WPA security with Funk security.
1 Make sure you have configured the communications and radio
parameters on your CK61 and that Funk is your security choice.
2 Open Intermec Settings. Tap (+) to expand Communications > 802.11
Radio > Funk Security > Profile X with "X" being "1" through "4."
3 For Association, select "WPA" and press Enter.
4 For 8021x, select "PEAP," "TLS," "TTLS," "LEAP," or "EAP-FAST"
and press Enter.
If you select "TTLS" or "PEAP:"
a Select User Name, type your user name, then press Enter.
b Select User Password, type a user password, then press Enter.
c For Validate Server Certificate, select "Yes," then press Enter.
Note: You must have the date on the CK61 set correctly when you enable
Validate Server Certificate.
d You must enter a User Name and Subject Name. You can also enter
a Server 1 Common name or Server 2 Common name if you want
to increase your level of security.
CK61 Mobile Computer with Windows Mobile User's Manual