Installing or Replacing Parts and Accessories
4. Use the special processor wrench shipped with your replacement processor assembly to lock
the processor in place on the system board:
a. Insert the special processor tool into the hole that runs down the side of the heatsink and
rotate it clockwise 180 degrees. Remove the tool.
b. Slide the sequencing plate to the closed position.
Slide The Sequencing Plate This way to Install
c. Screw in the four captive heatsink screws.
5. Connect the small power cable for the processor turbo fan to its connector on the system
board.
6. Place the power module in the system.
7. Slide the power module on the system board's metal mounting bracket so that the power
module's connector connects with the processor's connector. The two mounting screw holes
on the power module must align themselves with their screw holes on the system board's
metal mounting bracket. Screw in the power module's mounting screws.
8. Connect the power module power cable.
9. Replace the airflow guide. Replace the AGP retainer arm and lower the hard drive cage.
10. Replace the system covers and reattach all cables.
11. Verify that the processor works by turning the system.
2–32
technical reference guide