HP zx2000 Technical Reference Manual page 31

5. Pull the blue lever on the end of the retainer clip at the rear of the system and lift it out.
Removing the PCI Retainer Clip
6. Grasp the bulkhead end of the card and its opposite edge and lift the card out of its connector.
7. Insert a bulkhead blank, then replace the PCI retainer clip.
8. Replace the AGP retainer arm, making sure that the latches on the arm are inserted securely
into the slots on the rear edge of the system chassis and the retainer clip is securely holding
the AGP card in place. Lower the arm into place and tighten the blue screw.
9. Close the hard drive cage:
a. Depress the blue latch holding the hard drive cage in the upright position.
b. Lower the cage until it snaps into place.
Releasing and Lowering the Hard Drive Cage
10. Reattach the hard drive power connection and IDE or SCSI cable.
11. Replace the system covers and cables, and restart the workstation.
technical reference guide
Installing or Replacing Parts and Accessories
B
A
2–15