HP zx2000 Technical Reference Manual page 32

Installing or Replacing Parts and Accessories
installing or replacing an accessory or video card
NOTE: For specifications on your video card, visit the manufacturer's web site or refer to the
graphics documentation included in the acccessory kit.
To install or replace an accessory or video card:
1. Remove the existing card or bulkhead blank that is in the socket you want to use.
2. Grasp the bulkhead end of the card and its opposite edge and insert the card into its
connector.
Insert the New Card
3. Replace the PCI retainer clip. First insert the tab at the lower end, then press down until the
blank snaps into place.
4. Replace the AGP retainer arm and lower the hard drive cage.
5. Replace the covers and reconnect all cables.
6. Turn the system on, then execute the EFI firmware shell info io command to verify that
the accessory card has been properly installed. For more information on EFI, see Chapter 3.
2–16 technical reference guide