Replacing The System Board - HP zx2000 Technical Reference Manual

replacing the system board

1. Complete all of the steps in the section "Removing the System Board" on page 2-33.
2. Grasp the new system board by its edges and carefully place it in the system. Remember that
the system board keyholes must be aligned with their corresponding standoffs on the
system's chassis. Once the system board is in the system aligned with the keyhole standoffs,
slide it back toward the rear of the system. This locks the system board in place.
Aligning the System Board
3. Screw in the three rear backplane system board mounting screws.
4. Connect the system board cables.
5. Replace all cables and components on the system board:
❏
Memory DIMMs
❏
IDE devices — hard drives and optical drives
❏
Accessory and graphics cards
❏
Fan, LED and front-access USB connections
❏
Airflow guide
❏
Power connections and power supply
6. Replace the AGP retainer arm, lower the hard drive cage. Replace the system covers and
reconnect the cables.
7. Verify that the processor works by turning the system.
technical reference guide
Installing or Replacing Parts and Accessories
2–35