3.
Press down on the ribbed portion of the system fan housing (2), rotate the fan housing down, and
lift the unit out of the chassis.
Figure 4-13
To replace the system fan, reverse the previous steps.
CAUTION
direction is going out of the chassis to avoid overheating.
Memory fan
To remove the memory fan:
1.
Disconnect power from the system (
access panel
facing up.
2.
Disconnect the memory fan power plug from the system board (1).
NOTE
disconnected from the system board.
68
Chapter 4 Removal and replacement procedures
Removing the system fan
When installing the system fan, be sure that the fan is situated so that the airflow
(Access panel on page
If the fan is simply being moved to access the DIMMs, it does not need to be
Pre-disassembly procedures on page
61). Place the workstation on its side with the system board
55), and remove the
ENWW