Removing Memory Module - HP xw9400 Service And Technical Reference Manual

Removing memory module

1. Disconnect power from the system (
access panel
facing up.
CAUTION
installation, power off the workstation and unplug the power cord from the AC power outlet.
Wait until the LED on the back of the power supply turns off before removing memory. If you
do not unplug the power cord while installing memory, your memory modules might be
damaged and the system will not recognize the memory changes.
2. Press the green tab in on the memory fan housing (1) and lift the unit out of the chassis (2).
Figure 4-15
NOTE
in the rear slots.
3. Gently push out on the socket levers (1).
70 Chapter 4 Removal and replacement procedures
(Access panel on page
To ensure that memory modules are not damaged during removal or
Removing memory fan
The system fan (System fan on page 67
Pre-disassembly procedures on page
61). Place the workstation on its side with the system board
)must also be removed to access DIMMs
55), and remove the
ENWW