Replicating The Setup - HP xw9400 Service And Technical Reference Manual

When the Boot Block detects an invalid system ROM, the System Power LED blinks red eight times,
once every second, followed by a two-second pause. Also, you will hear eight beeps that correspond
to the blinks. A Boot Block recovery mode message is displayed on the screen (some models).
To recover the system after it enters Boot Block recovery mode:
1. If a removable medium is loaded in the workstation, remove it and power down the workstation.
2. Insert the appropriate ROMPaq removable medium in the workstation.
3. Power on the workstation.
If no ROMPaq removable medium is found, you are prompted to insert one and restart the
workstation.
If a setup password has been established, the Caps Lock light illuminates and you are prompted
to enter the password.
4. Enter the setup password.
If the system successfully starts from the removable medium and successfully reprograms the
ROM, the three keyboard lights illuminate.
5. Remove the removable medium and restart the system.
The following table lists the various keyboard light combinations used by the Boot Block ROM (when a
PS/2 keyboard is attached to the workstation) and explains the meaning and action associated with
each combination.
Table 3-2 PS/2 keyboard light combinations used by Boot Block ROM
Light
FailSafe Boot
Block Mode
Num Lock
Caps Lock
Num, Caps,
Scroll Lock
Num, Caps,
Scroll Lock
Diagnostic lights do not flash on USB keyboards.

Replicating the setup

The following procedures enable you to easily copy one setup configuration to other workstations of the
same model to provide faster, more consistent configuration of multiple workstations.
NOTE
To collect and replicate BIOS settings on multiple computers, use System Software Manager or
HP Client Manager Software. For more information, see http://www.hp.com/go/easydeploy.
38 Chapter 3 System management
State
Keyboard LED Activity
On
On
Blink On in sequence,
one at a time—N,C, SL
On
Setup configuration procedures require a diskette or a USB such as an HP DriveKey.
State/Message
ROMPaq diskette or ROMPaq CD not present, is bad, or drive not ready
Enter password
Keyboard locked in network mode
Boot Block ROM Flash successful.
Description
ENWW