4.
Lift the DIMM straight up, and remove it from the unit (2).
Figure 4-16
NOTE
when installing a DIMM.
Installing a memory module
NOTE
Because third-party DIMMs might not be electrically or thermally compatible, they are not
supported by HP.
1.
Disconnect power from the system (
access panel
facing up.
ENWW
Removing DIMM
DIMMs and DIMM sockets are keyed for proper installation. Be sure these guides align
HP only ships DIMMs that are electrically and thermally compatible with this product.
(Access panel on page
Pre-disassembly procedures on page
61). Lay the workstation on its side with the system board
Removing and replacing components
55) and remove the
71