Removing And Replacing Components; Disassembly Order - HP xw9400 Service And Technical Reference Manual

Removing and replacing components

This section discusses the procedures necessary to remove and install various hardware components
on your workstation.
Before servicing or upgrading your workstation:
1. Review the safety precautions and the
and Regulatory Information.
2. Locate and clear a suitable work area.
3. Shut down the system and remove power from the unit.
4. Gather your tools.
5. Remove all security devices.
6. Service your unit.
7. Restore power to your unit.
NOTE
components that obstruct or prevent the removal of the component.
If you are unsure how to remove a particular component, please do one of the following:
1. Refer to the appropriate section in this chapter.
2. If the content you desire is not referenced in this chapter, see
xw9400_manuals
3. See the manufacturer's web site for instructions for a third party (non-HP) component.

Disassembly order

Use the following table to determine the sequence in which to remove the major components.
Pre-disassembly (
disassembly procedures
on page 55)
Locks (Security lock
(optional) on page
ENWW
Prior to removing and replacing a component, make sure you remove all installed
and look under "Setup and Install – General" for instructions.
Pre-
61)
Access panel (Access panel on page
Hood sensor
(Smart cover sensor)
on page 64)
Front bezel (Front bezel
on page 62)
Service considerations on page
61)
(Hood sensor
Front panel I/O device assembly
panel I/O device assembly
on page 64)
50, as well as the Safety
www.hp.com/support/
(Front

Removing and replacing components

59