Status Tab; Log Tab - HP xw6400 Service And Technical Reference Manual

While tests are being performed, you can monitor the progress by viewing the Status tab. Any errors
that are detected are summarized in the Error Log. Select Save to save the report to floppy or a USB
Key Drive if attached.
If the diagnostics utility detects an error during a test, the user can mouse-over the failed text in the
Status tab to display additional information for the type of error and the error code.
To view all test failure information, Error Log. To view the status of all testing that has been performed,
click the Log tab.

Status tab

The Status tab displays the status of the selected tests. The type of test executed (for example,
Quick, Complete, Custom) is displayed. The main progress bar displays the percent complete of the
current set of tests. While testing is in progress, Cancel Testing is displayed. This selection will cancel
the test job.
After testing has completed, the Cancel testing button is replaced with two buttons, Select New
Tests and Retest. The Select New Tests button enables you to go back to the previous test selection
page to select a new set of tests. The Retest button retests the last set of tests executed. This enables
you to rerun the set of tests without having to go back to the test selection page.
The Status page also shows:
●
The devices being tested
● The tests that are running
●
The overall Test time
●
The individual Test times
●
The condition status of each test

Log tab

The Log tab consists of three views.
Test Log—Displays all tests that have been executed, number of times the test has been executed,
number of times the test failed, and the time it took to complete the test. The Clear Test Log button will
clear the contents of the Test Log.
Error Log—Displays the tests that have failed during the diagnostic testing. Besides displaying the
device and test, this section might also include error details. The description section describes the error
that the diagnostic test found. The Recommended Repair will give a recommended action that should
be performed to resolve the failed hardware. The error count is the number of times the test has failed.
The Clear Error Log button will clear the contents of the Error Log.
106 Chapter 5 System diagnostics and troubleshooting ENWW