Front Fan Removal (Optional) - HP Xw8200 - Workstation - 1 GB RAM Technical Reference Manual

4 Lower the PCI 3 or PCI Express
align with the socket. If installing a PCI Express card, plug in the power supply cable, required.
5 Close the PCI levers. If the PCI levers do not close, be sure all cards are properly seated and then try
again.
6 If installing a PCI Express card, plug in the power supply cable, if required.
1
2
Figure 4-2 PCI Installation

Front Fan Removal (Optional)

1 Disconnect power from the system
workstation on its side with the system board facing
2 Disconnect the connector
3 Unsnap the fan housing from the chassis and lift it out of the workstation.
3 card into the chassis. Verify that the keyed components of the card
4
3
(page 66), remove the access panel
1 from the header on the system board.
2
1
Figure 4-2 PCI Express Installation
(page
up.
REMOVAL AND REPLACEMENT OF COMPONENTS 85
4
3
5
71), and lay the