Front Fan Removal (Optional) - HP Xw8400 - Workstation - 4 GB RAM Technical Reference Manual

10. Connect memory riser cable P93 to the memory fan cable.
Figure 4-41

Front fan removal (Optional)

To remove the front fan:
1. Disconnect power from the system (
access panel
facing up.
2. Disconnect the fan wire from the connector on the system board.
3. Release the two card guide latches. Pivot the card guide toward the system board (1), and lift it
out of the chassis (2).
Figure 4-42
ENWW
Connect memory riser cable P93 to memory fan cable
(Access panel on page
Removing the card guide
Pre-disassembly procedures on page
57). Place the workstation on its side with the system board
Removing and replacing components
50), and remove the
81