Test Tab - HP xw6400 Service And Technical Reference Manual

Architecture—Shows the type of bus the computer uses as well as BIOS information. In addition, if the
bus is PCI, information about the PCI configuration is displayed.
Asset Control—Shows the serial number of the computer and also provides processor information.
Communication—Shows information about the computer parallel (LPT) and serial (COM) port settings,
USB, and network controller information.
Graphics—Shows information about the graphics subsystem of the computer.
Input Devices—Shows information about the type of keyboard and mouse.
Memory—Shows information about all memory in the computer, including memory on the board and
any memory modules installed.
Miscellaneous—Shows information obtained from the computers configuration memory (CMOS), BIOS
data area, Interrupt Vector table, and diagnostics component information.
Storage—Shows information about storage media connected to the computer, including all fixed disks,
floppy drives, and CD-ROM drives.
System—Shows product type, processor type and speed, coprocessor information, and information
about all ROMs in the computer.

Test tab

The Insight Diagnostics utility provides the capability to test all the major pieces of hardware in the
system. You can select from several types of tests:
Quick Test—Provides a predetermined script during which a sample of most hardware components is
exercised and requires no user intervention.
Complete Test—Provides a predetermined script during which most hardware components are fully
tested. You can select Interactive or Unattended tests. This will change the devices tested during the
Complete Test. More tests are available in the interactive mode, but these require user intervention.
Custom Test—Provides the most flexibility in controlling the testing of a system. The Custom Test mode
enables you to specifically select which devices, tests, and test parameters are run. You can select tests
that do not require any user interaction through the Interactive and Unattended test modes. More tests
are available in the interactive mode, but these tests require user intervention.
To begin testing:
1. Click the Test tab.
2. Select Type of Test to perform and then select Test Mode, either Interactive or Unattended.
3. Choose how you want the test to be executed, either Number of Loops or Total Test Time.
●
When choosing to run the test over a specified number of loops, enter the number of loops to
perform.
●
If you want to run the diagnostic test for a specified time period, enter the amount of time in
minutes.
4. Click Begin Testing in the lower right corner of the display to start the test.
ENWW HP Insight Diagnostics Offline Edition 105