Figure 4-9
To replace the hood sensor, reverse the previous steps.
Hood lock (Smart cover lock) (optional)
To remove the hood lock:
1.
Disconnect power from the system
access panel
2.
Using the FailSafe key, remove the two tamper-resistant screws that secure the hood lock to the
chassis.
Figure 4-10
3.
Disconnect the hood lock cable from the system board and remove the lock assembly.
To install the hood lock, reverse the previous steps.
ENWW
Removing the hood sensor
(Side access panel on page
Removing the hood lock
(Predisassembly procedures on page
63), and remove the top cover
Removal and replacement of components
57), remove the side
(Top cover on page
65).
67