Front Bezel - HP xw6400 Service And Technical Reference Manual

WARNING!
is powered off and that the power cord is disconnected from the electrical outlet.
1. Disconnect power from the system
(Predisassembly procedures on page
2. If necessary, unlock the side access panel. The keys are on the rear panel. Also, unlock any other
locks that are present (Cable lock or Padlock).
3. Pull up on the handle 1 and lift off the cover 2.
Figure 4-5
To replace the side access panel, align the bottom groove of the side access panel with the bottom edge
of the chassis, rotate the side access panel toward the chassis and press firmly until the latch engages.

Front Bezel

1. Lift up on the two release snaps 1 located on the front bezel.
2. Rotate the front bezel away 2 from the chassis to remove the bezel.
64 Chapter 4 Removal and replacement procedures
Before removing the workstation side access panel, be sure that the workstation
Opening the side access panel
57).
ENWW