Figure 4-32
Optical drive
To remove an optical drive:
1.
Disconnect power from the system
access panel
on page
2.
Disconnect the audio 1, data 2, and power 3 cables from the drive. The connector colors might be
different than illustrated.
NOTE
Figure 4-33
84
Chapter 4 Removal and replacement procedures
Identifying the correct power connections for a typical configuration
(Side access panel on page
64).
The audio cable is only required for Linux-based systems.
Disconnecting the cables from the optical drive
(Predisassembly procedures on page
63) and remove the front bezel
57), remove the side
(Front Bezel
ENWW