To remove the top cover:
1.
Disconnect power from the system
access panel
on page
2.
Push a flat screw driver into tab 1 on the rear of the chassis and gently pry the cover upward.
3.
Push the top cover toward the rear of the chassis and lift the cover up 2.
Figure 4-8
Hood sensor (Smart cover sensor)
To remove the hood sensor:
1.
Disconnect power from the system
access panel
2.
Disconnect the white 1x3 hood sensor connector from the in-line connector attached to the front
panel harness.
3.
Slide the hood sensor forward.
4.
Slide the hood sensor forward, push it down, and remove it from the chassis.
66
Chapter 4 Removal and replacement procedures
(Side access panel on page
64).
Removing the Top Cover
(Side access panel on page
(Predisassembly procedures on page
63), and remove the front bezel
(Predisassembly procedures on page
63).
57), remove the side
(Front Bezel
57) and remove the side
ENWW