Memory; Memory Module Requirements; Removing Memory Module - HP xw6400 Service And Technical Reference Manual

Figure 4-17
To install the power supply, reverse the previous steps.

Memory

Memory module requirements

●
Use only industry-standard, registered PC2-5300F DIMMs
●
Match DIMM pairs by size and type
●
No support for unbuffered memory

Removing memory module

1. Disconnect power from the system
access panel
on page
CAUTION
installation, power off the workstation and unplug the power cord from the AC power outlet.
Wait until the LED on the back of the power supply turns off before removing memory. If you
do not unplug the power cord while installing memory, your memory modules might be
damaged and the system will not recognize the memory changes.
2. Gently push outward 1 on the socket levers.
72 Chapter 4 Removal and replacement procedures
Removing the power supply
(Side access panel on page
69).
To ensure that memory modules are not damaged during removal or
(Predisassembly procedures on page
63), and remove the memory fan
57), remove the side
(Memory fan
ENWW