Preparation Before Installation; Safety Suggestions; Installation; Movement - Ruijie Reyee RG-NBS3100-24GT4SFP-V2 Installation Manual

Installation Guide
2

Preparation before Installation

2.1

Safety Suggestions

To avoid personal injury and device damage, carefully read the safety suggestions before you install the
RG-NBS3100 series.
Caution
The following safety suggestions do not cover all possible dangers.
2.1.1

Installation


Keep the chassis clean and free from any dust.

Do not place the equipment in a walking area.

Do not wear loose clothes or accessories that may be hooked or caught by the device during installation and
maintenance.

Turn off all power supplies and remove power sockets and cables before installing or uninstalling the device.
2.1.2

Movement


Do not frequently move the device.

When moving the device, note the balance and avoid hurting legs and feet or straining the back.

Before moving the device, turn off all power supplies and dismantle all power modules.
2.1.3

Electricity


Observe local regulations and specifications when performing electric operations. Relevant operators must
be qualified.

Before installing the device, carefully check any potential danger in the surroundings, such as ungrounded
power supply, and damp or wet ground or floor.

Before installing the device, find out the location of the emergency power supply switch in the room. First cut
off the power supply in the case of an accident.

Try to avoid maintaining the switch that is powered on alone.

Be sure to make a careful check before you shut down the power supply.

Do not place the device in a damp location. Do not let any liquid enter the chassis.
Caution

Any nonstandard and inaccurate electric operation may cause an accident such as fire or electrical shock,
thus causing severe even fatal damages to human bodies and the device.

Direct or indirect touch through a wet object on high-voltage and mains supply may bring a fatal danger.
5
Preparation before Installation