Table of Contents
Advertisement
Chapter 2
Messages and Recovery Procedures
Error Message PORT_SECURITY-6-ADDR_REMOVED: Address [dec]:[enet] exists on port
[chars]. It has been removed from port [chars].
Error Message PORT_SECURITY-6-ADDRESSES_REMOVED: Maximum system secure address count
reached. Some secure addresses configured on port [chars] removed.
Error Message PORT_SECURITY-6-VLAN_REMOVED: VLAN [int] is no longer allowed on port
[chars]. Its port security configuration has been removed.
QOSMGR Messages
This section contains the quality of service (QoS) manager messages. An incorrect QoS setting causes
these messages.
Error Message QOSMGR-3-CANNOT_ERR_DISABLE_DUE_TO_INTERNAL_ERR: Can not put port in
err-disable due to an internal error [chars].
OL-9641-01
A routed port is reconfigured as a switch port. The address in the previous switch
Explanation
configuration conflicts with the information in the running configuration and has been deleted.
[dec]:[enet] is the MAC address of the port. [chars] is the reconfigured port.
No action is required.
Recommended Action
Some configured and sticky MAC addresses on the specified port were removed from
Explanation
the configuration. The number of secure addresses that the system supports was exceeded. This
condition occurs only during hot swapping or port-mode changes (for example, when the port is
converted from a Layer 3 to a Layer 2 port). [chars] is the port.
No action is required.
Recommended Action
A configured VLAN has been excluded either due to port mode change or allowed
Explanation
VLAN list change and is removed from the configuration.
No action is required.
Recommended Action
This message means that an internal software error has occurred. [chars] is the
Explanation
description of the feature that the software cannot find.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the
"Error Message Traceback Reports" section on page
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
QOSMGR Messages
1-4.
2-49
Advertisement
Table of Contents
