Cisco IAD2424-8FXS - IAD 2424 Router System Message Manual page 44

GBIC_SECURITY_UNIQUE Messages
GBIC_SECURITY_UNIQUE Messages
This section contains the Cisco GBIC module and SFP module security messages that identify whether
the module is unique.
The switch supports SFP modules and does not support GBIC modules. Although the error message text
Note
refers to GBIC interfaces and modules, the messages from the switch actually refer to the SFP module
interfaces and modules.
Error Message GBIC_SECURITY_UNIQUE-3-DUPLICATE_GBIC: GBIC interface [dec]/[dec] is
a duplicate of GBIC interface [dec]/[dec].
Error Message GBIC_SECURITY_UNIQUE-4-DUPLICATE_SN: GBIC interface [dec]/[dec] has
the same serial number as another GBIC interface.
HARDWARE Messages
This section contains hardware messages.
Error Message HARDWARE-3-ASICNUM_ERROR: Port-ASIC number [dec] is invalid.
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
2-24
This message means that the SFP module was identified as a Cisco SFP module, but its
Explanation
vendor ID and serial number match that of another interface on the system. The first [dec]/[dec] is
the interface of the duplicate SPF module, and the second [dec]/[dec] is the interface of the existing
module.
Cisco SFP modules are assigned unique serial numbers. Verify that the module
Recommended Action
was obtained from Cisco or from a supported vendor.
Explanation This message means that the SFP module was identified as a Cisco SFP module, but its
serial number matches that of another interface on the system. [dec]/[dec] is the interface in which
the duplicate module is installed.
Cisco SFP modules are assigned unique serial numbers. Verify that the module
Recommended Action
was obtained from Cisco or from a supported vendor.
This message means that the port ASIC number used is invalid. Each port ASIC is
Explanation
identified by an ID. [dec] is the ASIC number.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Chapter 2 Messages and Recovery Procedures
1-4.
"Error
OL-9641-01