Table of Contents
Advertisement
VQPCLIENT Messages
Error Message VQPCLIENT-2-PROCFAIL: Could not create process for VQP. Quitting.
Explanation
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Error Message VQPCLIENT-2-SHUTDOWN: Interface [chars] shutdown by VMPS.
Explanation
is the interface name.
Recommended Action
shut down, verify the configuration on the VMPS.
Error Message VQPCLIENT-2-TOOMANY: Interface [chars] shutdown by active host limit.
Explanation
have requested access to that port. [chars] is the interface name.
Recommended Action
interface configuration command on the interface.
Error Message VQPCLIENT-3-IFNAME: Invalid interface ([chars]) in response.
Explanation
interface name. [chars] is the name of the unknown interface.
Recommended Action
Error Message VQPCLIENT-3-THROTTLE: Throttling VLAN change on [chars].
Explanation
interface more often than once every 10 seconds. The VLAN change is denied. [chars] is the
interface name.
Recommended Action
configuration. Verify that unexpected hosts are not connected to the port.
Error Message VQPCLIENT-3-VLANNAME: Invalid VLAN ([chars]) in response.
Explanation
switch. [chars] is the invalid VLAN name.
Recommended Action
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
2-80
This message means that an error occurred while creating a process for the VQP client.
Copy the message exactly as it appears on the console or in the system log.
This message means that the VMPS has directed that an interface be shut down. [chars]
No action is normally required. If you think that the port should not have been
This message means that the system has shut down an interface because too many hosts
To reactivate the port, remove the excess hosts, and enter a no shutdown
This message means that the VMPS has sent an unsolicited response with an unknown
Verify the VMPS configuration.
This message means that an attempt was made to change the VLAN assignment for an
No action is normally required. If the message recurs, verify the VMPS
This message means that the VMPS has specified a VLAN name that is unknown to the
Make sure that the VLAN exists on the switch. Verify the VMPS configuration.
Chapter 2
Messages and Recovery Procedures
1-4.
"Error
OL-9641-01
Advertisement
Table of Contents
