Table of Contents
Advertisement
Chapter 2
Messages and Recovery Procedures
Error Message DOT1X-5-ERR_INVALID_AAA_ATTR: Got invalid AAA attribute settings
[chars].
Explanation
invalid. [chars] is the text received from the RADIUS server.
Recommended Action
Error Message DOT1X-5-ERR_INVALID_TUNNEL_MEDIUM_TYPE: Got an invalid value [chars]
for TUNNEL_MEDIUM_TYPE [chars].
Explanation
[chars] is the text received from the RADIUS server.
Recommended Action
Error Message DOT1X-5-ERR_INVALID_TUNNEL_TYPE: Got an invalid value of [chars] for
TUNNEL_TYPE [chars].
Explanation
[chars] is the text received from the RADIUS server.
Recommended Action
Error Message DOT1X-5-ERR_PER_USR_IP_ACL: Applied per-user IP ACL was unsuccessful
on interface [chars].
Explanation
of an invalid per-user base (or pub) ACL from the RADIUS server. [chars] is the interface.
Recommended Action
Error Message DOT1X-5-ERR_PER_USR_MAC_ACL: Applied per-user MAC ACL was unsuccessful
on interface [chars].
Explanation
because of an invalid per-user base (or pub) ACL from the RADIUS server. [chars] is the interface.
Recommended Action
Error Message DOT1X-5-ERR_PROTO_TUNNELLING: Dot1x can not be enabled on protocol
tunnelling enabled ports.
Explanation
port. Trying to set 802.1x port-control to auto or force-unauthorized (force_unauth) mode on a
protocol-tunneling-enabled port, which is not allowed, caused this condition.
Recommended Action
OL-9641-01
This message means that the authorization settings obtained are either unsupported or
Change the settings to valid values.
This message means that the provided tunnel medium is either unsupported or invalid.
Change the value to a valid tunnel medium.
This message means that the provided tunnel type is either unsupported or invalid.
Change the value to a valid tunnel type.
This message means that 802.1x could not apply a per-user IP ACL, possibly because
Examine the RADIUS pub ACL, and configure a valid one.
This message means that 802.1x could not apply a per-user MAC ACL, possibly
Examine the RADIUS pub ACL, and configure a valid one.
This message means that 802.1x could not be enabled on the protocol-tunneling-enabled
Change the access VLAN on the interface, and then enable 802.1x.
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
DOT1X Messages
2-13
Advertisement
Table of Contents
