Table of Contents
Advertisement
DOT1X Messages
Error Message DOT1X-4-MSG_ERR: Unknown message event received.
Explanation
Recommended Action
configuration command. If this message recurs, reload the device.
Error Message DOT1X-4-PROC_START_ERR: Dot1x unable to start.
Explanation
Recommended Action
configuration command. If this message recurs, reload the device.
Error Message DOT1X-4-UNKN_ERR: An unknown operational error occurred.
Explanation
system error.
Recommended Action
Error Message DOT1X-5-ERR_CHANNELLING: Dot1x can not be enabled on Channelling
ports.
Explanation
set 802.1x port-control to auto or force-unauthorized (force_unauth) mode on a channeling port,
which is not allowed, caused this condition.
Recommended Action
Error Message DOT1X-5-ERR_DYNAMIC: Dot1x can not be enabled on Dynamic ports.
Explanation
to set 802.1x port-control to auto or force-unauthorized (force_unauth) mode on a dynamic mode
port, which is not allowed, caused this condition.
Recommended Action
Error Message DOT1X-5-ERR_DYNAMIC_VLAN: Dot1x can not be enabled on dynamic VLAN
ports.
Explanation
Trying to set 802.1x port-control to auto or force-unauthorized (force_unauth) mode on a dynamic
VLAN port, which is not allowed, caused this condition.
Recommended Action
802.1x.
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
2-12
This message means that the 802.1x process received an unknown message event.
Restart the 802.1x process by entering the dot1x system-auth-control global
This message means that the system failed to create the 802.1x process.
Restart the 802.1x process by entering the dot1x system-auth-control global
This message means that the 802.1x process cannot operate because of an internal
No action is required.
This message means that 802.1x could not be enabled on the channeling port. Trying to
Disable channeling on the interface, and then enable 802.1x.
This message means that 802.1x could not be enabled on the dynamic mode port. Trying
Disable dynamic mode on the interface, and then enable 802.1x.
This message means that 802.1x could not be enabled on the dynamic VLAN port.
Disable dynamic VLAN configuration on the interface, and then enable
Chapter 2
Messages and Recovery Procedures
OL-9641-01
Advertisement
Table of Contents
