Cisco IAD2424-8FXS - IAD 2424 Router System Message Manual page 50

Ethernet access switches
Table of Contents

Advertisement

IGMP_QUERIER Messages
IGMP_QUERIER Messages
This section contains the IGMP querier messages.
Error Message IGMP_QUERIER-4-NO_IP_ADDR_CFG: The IGMP querier cannot send out
General Query messages in VLAN [dec] because there is no IP address configured on
the system.
Error Message IGMP_QUERIER-4-PIM_ENABLED: The IGMP querier is operationally disabled
in VLAN [dec] because PIM has been enabled on the SVI.
Error Message IGMP_QUERIER-4-SNOOPING_DISABLED: The IGMP querier is operationally
disabled in VLAN [dec] because IGMP snooping has been disabled in this VLAN.
Error Message IGMP_QUERIER-6-PIM_DISABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because PIM is no longer enabled on the SVI.
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
2-30
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Explanation
This message means that you must specify an IP address for the IGMP querier at either
the global or per-VLAN level. [dec] is the VLAN number.
Recommended Action
Configure a source IP address for the IGMP querier.
This message means that PIM was detected on the SVI. Do not enable the IGMP querier
Explanation
when PIM is enabled on the SVI. [dec] is the VLAN number.
Ensure that PIM is disabled on the SVI.
Recommended Action
This message means that IGMP snooping was detected in a disabled state on this
Explanation
VLAN. The IGMP querier function should not be operationally enabled when IGMP snooping is
disabled. [dec] is the VLAN numbers.
Confirm that IGMP snooping is enabled both globally and on the VLAN.
Recommended Action
This message means that Protocol-Independent Multicast (PIM) is disabled on the
Explanation
switch virtual interface (SVI), and the IGMP querier function is now enabled. [dec] is the VLAN
number.
Recommended Action
No action is required.
Chapter 2
Messages and Recovery Procedures
1-4.
"Error
OL-9641-01

Advertisement

Table of Contents
loading

Table of Contents