Cisco IAD2424-8FXS - IAD 2424 Router System Message Manual page 56

PLATFORM_PBR Messages
Error Message PLATFORM_PBR-3-UNSUPPORTED_RMAP: Route-map [chars] not supported for
Policy-Based Routing.
Explanation
contains an action that is not supported on this platform. This is a hardware limitation. [chars] is the
route-map.
Recommended Action
ip next-hop ip-address route-map configuration command to reconfigure the route map to use only
these supported actions.
Error Message PLATFORM_PBR-4-CPU_SUPPORTED_ACTION: Set action in sequence [dec] of
route-map [chars] supported by forwarding to CPU.
Explanation
contains an action that is not supported in hardware, so the packets are forwarded to the CPU for
processing. The route-map actions that invoke this forwarding are set interface, set ip default
next-hop, set default interface, or set ip df. [dec] is the action number, and [chars] is the
route-map.
Recommended Action
reconfigure the route map action to route the packet to the specified next hop.
Error Message PLATFORM_PBR-4-RETRY_INSTALL: Route-map [chars] installed in hardware
upon retry.
Explanation
into the hardware. One or more route-maps previously failed to load because of lack of resources.
[chars] is the route-map.
Recommended Action
Error Message PLATFORM_PBR-4-SDM_MISMATCH: [chars] requires sdm template routing.
Explanation
PBR.
Recommended Action
routing configuration command, and then reload the switch by using the reload privileged EXEC
command.
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
2-36
This message means that the route-map attached to an interface for policy routing
Use the route-map map-tag permit global configuration command and the set
This message means that the route-map attached to an interface for policy-based routing
Use the set ip next-hop ip-address route-map configuration command to
This message means that the PBR manager was able to fit the complete configuration
No action is required.
This message means that the routing template is not enabled. [chars] is the text string
Modify the SDM template to enable the routing template. Use the sdm prefer
Chapter 2 Messages and Recovery Procedures
OL-9641-01