Cisco IAD2424-8FXS - IAD 2424 Router System Message Manual page 42

GBIC_SECURITY Messages
GBIC_SECURITY Messages
This section contains the Cisco Gigabit Interface Converter (GBIC) and small form-factor pluggable
(SFP) module security messages. The GBIC and SFP modules have a serial EEPROM that contains the
serial number, security code, and cyclic redundancy check (CRC). When the module is inserted into the
switch, the software reads the EEPROM to recompute the security code and CRC. The software
generates an error message if the CRC is invalid or if the recomputed security code does not match the
one stored in the EEPROM.
The switch supports SFP modules and does not support GBIC modules. Although the error message text
Note
refers to GBIC interfaces and modules, the messages from the switch actually refer to the SFP module
interfaces and modules.
Error Message GBIC_SECURITY-4-EEPROM_CRC_ERR: EEPROM checksum error for GBIC in
[chars].
Error Message GBIC_SECURITY-4-EEPROM_READ_ERR: Error in reading GBIC serial ID in
[chars].
Error Message GBIC_SECURITY-4-EEPROM_SECURITY_ERR: GBIC in [chars] failed security
check.
Error Message GBIC_SECURITY-4-GBIC_INTERR: Internal error occurred in setup for GBIC
interface [chars].
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
2-22
This message means that the GBIC in the specified port has invalid EEPROM data.
Explanation
[chars] is the port in which the GBIC is inserted.
Remove the GBIC from the port.
Recommended Action
Explanation This message means that an error occurred while the switch was reading the GBIC type
from the EEPROM. [chars] is the port in which the GBIC is inserted.
Remove the GBIC from the port.
Recommended Action
The GBIC in the specified port has invalid EEPROM data. [chars] is the port in which
Explanation
the GBIC is inserted.
Remove the GBIC from the port.
Recommended Action
This message means that the system could not allocate resources or had some other
Explanation
problem during the setup for the specified SFP module interface. [chars] is the interface in which
the SFP module is installed.
Recommended Action Reload the switch by using the reload privileged EXEC command. If the
problem persists, find out more about the error by using the show tech-support privileged EXEC
command and by copying the error message exactly as it appears on the console or system log and
Chapter 2 Messages and Recovery Procedures
OL-9641-01