Residual Risks - Daikin PE-ADDA200 Service And Installation Manual

CAUTION - Risk of Arc Flash: A substantial amount of energy can be stored in the capacitor bank
even if its voltage is below 60 V. Do not short-circuit the DC-Link unless the capacitor
bank is completely discharged. Before commencing any mechanical work on the
inverter, discharge completely the DC-Link by means of a suitable external device or
allow enough time for the DC-Link to be completely discharged (< 5 V).
WARNING – Once the cover has been opened, observe ESD precautions and wear protective gloves
against electrostatic discharge during maintenance or assembly.

2.3 Residual risks

Following the application of the derived corrective / improvement measures of the risk analysis, a series of
residual risks have been identified, defined in accordance with the ISO 12100 standard: risk remaining after
protective measures have been implemented.

PE-ADDA200 product may only be installed in machines designated by the manufacturer Daikin Applied
Europe S.p.A. In case of use outside the specifications set out in this manual, the manufacturer's
responsibilities Daikin Applied Europe S.p.A. they come to decay.
 During the transport and handling of the product, it is strictly recommended to use a forklift or pallet
truck. It is strictly forbidden to carry the product by hand.

In the assembly and adjustment phases, it is recommended to use suitable tools and PPE (Personal
protective equipment) with adequate strength and mechanical protection.

Before performing any maintenance and / or adjustment operations on the product, make sure that it
has been disconnected and that the capacitors have been discharged, as indicated on the warning label
on the product.
Daikin Applied Europe S.p.A
SERVICE and INSTALLATION MANUAL
Compressor Inverter PE-ADDA200
Label: Risk of Electric shock
Fig. 1
Fig. 2 ESD precautions label
Page 6 of 51
Rev. 0.3