Read/Write Parameters; Firmware Download - Daikin PE-ADDA200 Service And Installation Manual

9.1.8

Read/Write Parameters

It is possible to read/write the parameters individually or all together.
When a parameter value is shown in red it means that its value hasn't been refreshed. The value is written in
black after it has been updated.

To read a single parameter select it and press the button "R" in the toolbar.

To write a single parameter, open the keys if necessary, select it and press the button "W" in the toolbar.
 To read all parameters, in the Toolbar select "Parameters/Read All". At the end all the parameters in the
project will be refreshed and it will be possible to save the project with ".VFD" extension.

To write all parameters, make sure the VFD is stopped, open the keys if necessary (P60 for reserved
parameters and P99 for factory parameters), in the Toolbar select "Parameters/Write All".
9.1.9

Firmware Download

There are two ways to start the firmware download:

Click on the related button in the toolbar
 Click on the "Upgrade Firmware" button in the main page.
Daikin Applied Europe S.p.A
SERVICE and INSTALLATION MANUAL
Compressor Inverter PE-ADDA200
Fig. 27
Page 37 of 51
Rev. 0.3