Configuring Channel Groups On T1/E1 To Support Data Under Shdsl Controller - Cisco 2431 - IAD Router Software Configuration Manual

Configuring T1/E1 Interfaces

Configuring Channel Groups on T1/E1 to Support Data Under SHDSL Controller

To support data under symmetric high bit-rate digital subscriber line (SHDSL) controller, use the
following procedure either to configure a new T1/E1 interface for channelized T1/E1 (CT1) or PRI or
to change the configuration of an existing interface.
Perform the following steps to configure channel groups on T1/E1 to support data under SHDSL
controller.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router# enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
ip routing
Example:
Router(config)# ip routing
Step 4
controller dsl slot/port
Example:
Router(config)# controller dsl 2/4
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
3-10
enable
configure terminal
ip routing
controller dsl slot/port
mode {atm|t1|e1)
controller t1 slot/port
channel-group channel-group-number timeslots range
interface type number
ip address ip address subnet mask
exit
Ctrl-z
Chapter 3 Configuring with the Command-Line Interface
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
Enables routing protocols as required for your global
configuration. This example uses IP routing.
Selects the DSL interface to configure. Controller
numbers vary. See Port Numbering Conventions,
page 1-5.
OL-4306-03