Cisco 2431 - IAD Router Software Configuration Manual page 77

Chapter 4 Configuring Voice over IP
Answer no. You now enter the normal operating mode of the Cisco IAD.
Note
After a few seconds, you see the user EXEC prompt (
Step 3
enable mode:
Router> enable
Password: < password >
The prompt changes to the privileged EXEC (enable) prompt (
Router#
Enter the configure terminal command to enter global configuration mode:
Step 4
Router# configure terminal
Router(config)#
The Cisco IAD enters global configuration mode, indicated by the
If you have not configured the Cisco IAD before, or you want to change the configuration, use Cisco
Step 5
IOS commands to configure global parameters, passwords, network management, and routing protocols.
In this example, IP routing is enabled:
Router(config)# ip routing
For complete information about global configuration commands, see the Cisco IOS configuration guides
and command references.
Step 6 If you have not already done so, configure the network module or WAN interface card that you plan to
use for IP traffic. For instructions, see your Cisco IAD hardware installation and software configuration
guides or the configuration note for the network module or WAN interface card.
To configure another interface, enter the exit command to return to the
Step 7
Step 8 To configure the Cisco IAD for voice traffic, see the VoIP references in the
page 4-1.
To exit configuration mode and return to the enable prompt, when you finish configuring interfaces,
Step 9
press Ctrl-Z. To see the current operating configuration, including any changes you just made, enter the
show running-config command:
Router# show running-config
To see the configuration currently stored in NVRAM, enter the show startup-config command at the
enable prompt:
Router# show startup-config
The results of the show running-config and show startup-config commands differ if you have made
Step 10
changes to the configuration but have not yet written them to NVRAM. To write your changes to
NVRAM and make them permanent, enter the copy running-config startup-config command at the
enable prompt:
Router# copy running-config startup-config
Building configuration. . .
[OK]
Router#
OL-4306-03
If the current configuration is valid, you enter the normal operating mode automatically.
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
Configuring the Voice Interface
). Type enable and the password to enter
Router>
):
Router#
Router(config)#
Router(config)#
"Prerequisites" section on
prompt.
prompt.
4-3