Completing The Configuration; Chapter 3 Configuring With The Command-Line Interface - Cisco 2431 - IAD Router Software Configuration Manual

Chapter 2 Using the setup Command Facility
choose clock rate from above
Configure IP on this interface? [yes]:

Completing the Configuration

When you have all the information that the setup command facility has prompted you for, the
configuration appears.
For sample configurations, see
Note
To complete your configuration, follow these steps:
A setup command facility prompt asks if you want to save this configuration, with the following options:
Step 1
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you answer 0, the configuration information you entered is not saved, and you return to the Cisco IAD
enable prompt (
If you answer 1, you return to setup without saving the configuration.
If you answer 2, the configuration is saved and you are returned to the user EXEC prompt
When the messages stop appearing on your screen, press Enter to get the
Step 2
The
Step 3
completed a basic Cisco IAD configuration. However, this is not a complete configuration. At this point
you have two choices:
•
•
OL-4306-03
56, 64
IP address for this interface: 1.0.0.1
Subnet mask for this interface [255.0.0.0] :
Class A network is 1.0.0.0, 8 subnet bits; mask is /8
). Enter setup to return to the System Configuration Dialog.
Router#
prompt indicates that you are now at the command-line interface (CLI) and you have just
Router>
Run the setup command facility again and create another configuration. Enter the following:
Router> enable
Password: password
Router# setup
Modify the existing configuration or configure additional features with the CLI as described in
Chapter 3, "Configuring with the Command-Line Interface."
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
[56]:
Appendix A, "Cisco IAD2430 Series Configuration Examples."
Completing the Configuration
(Router>)
prompt.
Router>
2-13
.