Configuring A Wic-1Dsu-T1/E1 Serial Wan Interface Card - Cisco 2431 - IAD Router Software Configuration Manual

Configuring a WIC-1DSU-T1/E1 Serial WAN Interface Card

Command or Action
Step 7
exit
Example:
Router(config-if)# exit
Step 8
connect id serial-1 controller-2 tdm-group-no-2
Example:
Router(config)# connect

Configuring a WIC-1DSU-T1/E1 Serial WAN Interface Card

You can manually configure the synchronous serial interfaces on a WIC-1DSU-T1/E1 serial interface
card by entering Cisco IOS commands on the command line. This method, called configuration mode,
provides the greatest power and flexibility.
Before you begin, disconnect all WAN cables from the Cisco IAD to prevent it from running the
Note
AutoInstall process. Whenever you power on the Cisco IAD, if there is a WAN connection on both ends
and the Cisco IAD does not have a valid configuration file stored in NVRAM (for instance, when you
add a new interface), the Cisco IAD tries to run AutoInstall. It can take several minutes for the Cisco
IAD to determine that AutoInstall is not connected to a remote TCP/IP host.
Before you begin configuring the synchronous serial interface, make sure to do the following:
•
•
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
3-20
Connect a console to the Cisco IAD.
Power on the Cisco IAD.
enable
configure terminal
ip routing
interface type number
ip address ip address subnet mask
half-duplex timer dcd-drop-delay value
clockrate value
dce-terminal-timing-enable
invert-txc
nrzi-encoding
exit
Ctrl-z
Chapter 3 Configuring with the Command-Line Interface
Purpose
Exits serial interface mode.
Configures cross-connect pass-through between physical
serial interface and a controller.
OL-4306-03