Configuring Tdm To Tdm - Cisco 2431 - IAD Router Software Configuration Manual

Chapter 3 Configuring with the Command-Line Interface

Configuring TDM to TDM

Perform the following steps to configure TDM connect for data (also referred to as pass-through).
SUMMARY STEPS
1.
2.
3.
4.
5.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router# enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
controller t1/e1 slot/port
Example:
Router(config)# controller t1 0/2
Step 4
tdm-group tdm-group-no timeslot timeslot-list
type
Example:
Router(config-controller)# tdm-group 1 timeslots
13-20
Step 5
exit
Example:
Router(config-if)# exit
OL-4306-03
enable
configure terminal
controller t1/e1 slot/port
tdm-group tdm-group-no timeslot timeslot-list type
exit
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
Enters controller configuration mode for controller 1 (the
trunk controller for the T1-PBX port).
DS0-group number should be different from
Note
channel-group number and TDM-group number
under the same controller.
Configures a TDM channel group for T1/E1. When
configuring cross-connect for data traffic only, do not
specify the type option. The type option applies only if
the mode cas command is enabled.
The TDM-group number should be different
Note
from the DS0-group number and the
channel-group number under the same controller.
Exits to global configuration mode.
Configuring T1/E1 Interfaces
3-17