Where To Go Next - Cisco 2431 - IAD Router Software Configuration Manual

Where to Go Next

Figure 1-11
Cisco IAD model number:
Cisco IAD2432-24FXS
with
Cisco VIC2-4FXO interface card
Figure 1-12
Cisco IAD model number:
IAD2431-1T1E1
Where to Go Next
Now that you have learned some Cisco IOS software basics and seen some typical deployment scenarios,
you can begin to configure the router by using the command-line interface (CLI).
Remember that:
•
•
•
•
Go to
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
1-10
T1/E1 WAN Interface with Analog FXS and FXO User Interfaces
T1
WAN
T1/E1 WAN Interface with T1 Interface to PBX User Interface
T1
WAN
You can use the question mark (?) and arrow keys to help you enter commands.
Each command mode restricts you to a set of commands. If you have difficulty entering a command,
check the prompt and then enter the question mark (?) for a list of available commands. You might
be in the wrong command mode or be using the wrong syntax.
To disable a feature, generally enter the keyword no before the command; for example, no ip
routing.
You need to save your configuration changes to NVRAM so that the changes are not lost if there is
a system reload or power outage.
Chapter 2, "Using the setup Command Facility,"
Chapter 1 Understanding Interface Numbering and Cisco IOS Software Basics
Ethernet
Multiple FXS and FXO
IAD
Ethernet
T1
IAD
to begin configuring the router.
Analog
telephones
24 FXS
voice ports
4 FXO
voice ports
Distribution
panel
PBX
PBX
PBX
OL-4306-03