Verifying The Hostname And Password - Cisco 2431 - IAD Router Software Configuration Manual

Chapter 3 Configuring with the Command-Line Interface
Command or Action
Step 5
line console
Example:
Router(config)# line console 0
Step 6
exec-timeout
Example:
Router(config-line)# exec-timeout 0 0
Step 7
exit
Example:
Router(config-line)# exit
Step 8
end
Example:
Router(config-if)# end

Verifying the Hostname and Password

To verify that you configured the correct hostname and password, follow these steps:
Step 1 Enter the show config command:
Router(config)# show config
Using 1888 out of 126968 bytes
!
version XX.X
.
.
.
!
hostname IAD2430
!
enable secret 5 $1$60L4$X2JYOwoDc0.kqa1loO/w8/
.
.
.
Check the hostname and encrypted password displayed near the top of the command output.
Exit global configuration mode and attempt to reenter it, using the new enable password:
Step 2
Router# exit
.
.
.
Router con0 is now available
Press RETURN to get started.
Router> enable
OL-4306-03
Purpose
Enters line configuration mode to configure the console
port. When you enter line configuration mode, the
prompt changes to
If no input is detected during the interval, the EXEC
facility resumes the current connection. If no
connections exist, the EXEC facility returns the terminal
to the idle state and disconnects the incoming session.
To specify no timeout, enter the
Note
exec-timeout 0 0 command.
Exits to global configuration mode.
Returns you to privileged EXEC mode.
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
Configuring the Hostname and Password
.
Router(config-line)#
3-3