Verifying Atm Configuration - Cisco 2431 - IAD Router Software Configuration Manual

Chapter 3 Configuring with the Command-Line Interface
Command or Action
Step 13
exit
Example:
Router(config)# exit
Step 14
show interface atm slot/port
Example:
Router> show interface atm 1/0

Verifying ATM Configuration

Use the following commands to verify the ATM configuration:
•
•
•
•
•
•
•
•
OL-4306-03
To verify current configuration and to view the status for all controllers, use the show
running-config command.
To view ATM controller statistics, use the show controllers atm slot/port command.
To verify the PVC status, use the show atm vc command. Make sure that active PVCs are up.
To help identify ATM-related events as they are generated, use the debug atm events command.
To indicate which interfaces are having trouble, use the debug atm errors command.
To identify an entry for the ATM interface you configured and to show an entry for the ATM
slot/port that you configured, use the show ip route command.
To display the configured list of ATM static maps to remote hosts on an ATM network, use the show
atm map command.
To view the status of an ATM interface, use the show interface atm slot/port command. Make sure
that the ATM slot/port and line protocol are up, as shown in the following example:
Router# show interface atm1/0
ATM 1/0 is up, line protocol is up
Hardware is DSLSAR (with Alcatel ADSL Module)
MTU 4470 bytes, sub MTU 4470, BW 800 Kbit, DLY 2560 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Keepalive not supported
Encapsulation(s):AAL5 PVC mode
24 maximum active VCs, 256 VCs per VP, 2 current VCCs
VC idle disconnect time:300 seconds
Last input never, output 00:00:01, output hang never
Last clearing of "show interface" counters 03:16:00
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
2527 packets input, 57116 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
10798 packets output, 892801 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Router# show atm vc
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
Configuring 1-Port ADSL/SHDSL WAN Interface Card
Purpose
Exits from global configuration mode.
Verifies the ATM interface configuration.
3-35