Verifying Your Atm Interface Configuration - Cisco 2431 - IAD Router Software Configuration Manual

Integrated access devices
Hide thumbs Also See for 2431 - IAD Router:
Table of Contents

Advertisement

Chapter 3
Configuring with the Command-Line Interface
Command or Action
Step 13
encapsulation
{aal5ciscoppp|aal5mux|aal5nlpid|aal5snap}
Example:
Router(config-if-vc)# encapsulation aal5autoppp
virtual-template 1
Step 14
exit
Example:
Router(config-if-vc)# exit
Step 15
Repeat Step 8 through Step 12 for each additional ATM
PVC to be configured.
Step 16
no shutdown
Example:
Router(config-if)# no shutdown
Step 17
exit
Example:
Router(config-if)# exit
Step 18
exit
Example:
Router(config)# exit

Verifying Your ATM Interface Configuration

To verify the ATM interface configuration, enter the show interface atm 0 privileged EXEC command.
The following example shows typical output from the show interface atm 0 command:
Router# show interface atm 0
ATM0 is up, line protocol is up
Hardware is PQUICC Atom1
MTU 1500 bytes, sub MTU 1500, BW 2304 Kbit, DLY 20000 usec,
Encapsulation ATM, loopback not set
Keepalive not supported
Encapsulation(s):, PVC mode
512 maximum active VCs, 4 current VCCs
VC idle disconnect time:300 seconds
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue:0/75/0/0 (size/max/drops/flushes); Total output drops:0
Queueing strategy:None
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
OL-4306-03
reliability 255/255, txload 1/255, rxload 1/255
20486 packets input, 368419 bytes, 0 no buffer
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
Purpose
(Optional) Configures the ATM adaptation layer (AAL)
and encapsulation type.
aal5ciscoppp for Cisco PPP over AAL5
aal5mux for AAL5+MUX (multiplexer)
aal5nlpid for AAL5+NLPID (Network Layer
Protocol Identifier)
aal5snap for AAL5+LLC/SNAP (the default)
Exits interface-atm-vc configuration mode.
Configures any additional ATM PVCs.
Activates the ATM interface.
Exits ATM interface configuration mode.
Exits global configuration mode.
Configuring ATM T1-WAN Ports
3-31

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Iad2431-16fxsIad2432-24fxsIad2430 series

Table of Contents