Cisco 2431 - IAD Router Software Configuration Manual page 64

Configuring ATM T1-WAN Ports
Command or Action
Step 5
exit
Example:
Router(config-ctrl)# exit
Step 6
interface type number
Example:
Router(config)# interface atm 0
Step 7
ip address ip address subnet mask
Example:
Router(config-if)# ip address 172.16.74.1
255.255.255.0
Step 8
atm uni-version version-number
Example:
Router(config-if)# atm uni-version 3.1
Step 9
atm ilmi-keepalive seconds
Example:
Router(config-if)# atm ilmi-keepalive
Step 10
pvc name vpi/vci
Example:
Router(config-if)# pvc cisco 0/8
Step 11
protocol ipv6 ipv6-address
Example:
Router(config-if-vc)# protocol ipv6 address
2001:0DB8:2222::72/32
Step 12
vbr-rt peak-rate average-rate burst
Example:
Router(config-if-vc)# vbr-rt 640 320 80
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
3-30
Chapter 3 Configuring with the Command-Line Interface
Purpose
Exits to controller mode.
Enters ATM configuration mode for interface ATM 0.
(Optional) Assigns an IP address to the asymmetric
digital subscriber line (ADSL) or symmetric high bit-rate
digital subscriber line (SHDSL) ATM interface.
(Optional) Specifies an ATM user network interface
(UNI) version number.
(Optional) Enables Integrated Local Management
Interface (ILMI) keepalives.
If you enable ILMI keepalives without specifying the
seconds, the default time interval is 3 seconds.
Enters atm-virtual-circuit (interface-atm-vc)
configuration mode, and configure a new ATM PVC by
assigning a name (optional) and VPI/VCI numbers.
The default traffic shaping is unspecified bit rate (UBR);
the default encapsulation is ATM adaption layer 5+
(AAL5+), Logical Link Control Protocol (LLC),
Subnetwork Access Protocol (SNAP).
(Optional) Enables IP connectivity and creates a
point-to-point IP address for the VC.
(Optional) Configures the PVC for real-time variable bit
rate (VBR), VBR-nrt (non-real time), unspecified bit rate
(UBR) UBR+, unspecified bit rate constant bit rate
(CBR), available bit rate (ABR) traffic shaping.
Peak rate—peak information rate (PIR).
•
For SHDSL ports, set the peak rate for the trained
line rate minus 8 kb/s.
Average rate—average information rate (AIR).
•
Burst—burst size in cells.
•
OL-4306-03