Resetting The Microprocessor - Denon AVR-4311CI Owner's Manual

Symptom
Cannot login to • Login information is incorrect. Check if the Username for Napster
Napster. ("Incorrect has been properly entered. Re-enter the Password. (Password is
Username or not displayed.)
Password" is http://www.napster.com/choose/index_default.html
displayed.)
Cannot login to • Login information is incorrect. Check if the "Email address" for
Pandora. ("Email Pandora has been properly entered. Re-enter the "Password".
address" or (Password is not displayed.)
"Password" is http://www.pandora.com/denon
displayed.)
GRemote Control UnitH
Symptom
The set cannot be • Batteries are worn out. Replace with new batteries.
operated with the • Operate the remote control unit within a distance of about 23 ft /
remote control unit. 7 m from this unit and at an angle of within 30°.
• Remove any obstacle between this unit and the remote control
unit.
• Insert the batteries in the proper direction, checking the q and
w marks.
• The set's remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
• Make sure the remote control IDs of the main unit and remote
control unit match. If the IDs do not match, "AVAMPz" (z is the
main unit's remote control ID) appears on the display of this unit
when the remote control unit is operated.
• The ZONE SELECT setting is not correct. Press
select the zone to operate.
• The operation mode does not match the settings of the device to
operate. Check the operation mode.
138
Cause/Solution
Cause/Solution
ZONE SELECT
to

Resetting the microprocessor

Page
42, 103
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values.
ON/STANDBY
44
Page
124
124
124
1
Turn off the power using
124
2
Press ON/STANDBY
124
SIMULATION
.
3
Once the display starts flashing at intervals of about 1 second, release the two
105, 114, buttons.
118
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
108
108
STANDARD
DSP SIMULATION
ON/STANDBY
.
while simultaneously pressing STANDARD and DSP