Quick Select Function; Personal Memory Plus Function; Last Function Memory; Backup Memory - Denon AVR-1909 Owner's Manual

Quick Select Function

With this function, the currently playing input source, input mode,
surround mode, MultEQ settings and volume can be stored in the
memory.
Set the input source, surround mode, MuItEQ,
1
Dynamic EQ, Dynamic Volume, Front Speaker
settings and volume to the conditions you want to
store.
QUICK SELECT
Press and hold the desired
2
"Memory" appears on the display.
The current settings will be memorized.
[Quick Select Defaults]
Input Source
Quick Select 1 DVD
TV/CBl
Quick Select 2
Quick Select 3 VCR
aUiCK SELECT
• To call out the settings, press
settings were stored.
• The Quick Select name can be changed (iGf'page 36).
.N.h.
Input sources stored with the quick select function cannot be selected
if they have been deleted at menu" Manual Setup" - "Option Setup" -
"Source Delete" (iGf'page 36). In this case, store them again.

Personal Memory Plus Function

This function sets the settings (input mode, surround mode, HOM I
output mode, MultEQ, Dynamic EQ, DynamicVolume, audio delay
etc.) last selected for the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
The surround parameters, tone settings and the volumes of the
different speakers are stored for the individual surround modes.

Last Function Memory

This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.

Backup Memory

The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.
until

Resetting the Microprocessor

Perform this procedure if the display is abnormal or if operations
Volume
cannot be performed.
-40 dB
When the microprocessor is reset, all the settings are reset to
-40 dB
their default values.
1
-40 dB
Turn ofT the power using
at which the desired
<POWER>
Press
2
<INPUT MODE>
Once the display starts flashing at intervals of about 1
3
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
<POWER>.
while simultaneously pressing
<SPEAKERS>.
and
ENGLISH
,
L'
I
.,
:.
64